HERMA PE white PRINT (810)
White, matt, opaque polyethylene film with special surface treatment for better printability, suitable for later inscription of the labels
Technical data
| Grammage | approx. 60 g/m² | ISO 536 |
| Caliper | approx. 85 µm | ISO 534 |
| Tensile stress MD | approx. 40 N/mm² | ISO 527 |
| Tensile stress CD | approx. 34 N/mm² | ISO 527 |
| Opacity | approx. 90 % | ISO 2471 |
Application and use
HERMA PE white PRINT (810) combines the high print quality of coated paper with the durability of PE films. With HERMA PE white PRINT (810) an excellent print quality can be achieved in all traditional printing methods such as flexo, letterpress, screen and offset printing. Furthermore the film is perfectly suited for subsequent inscription with matrix or thermal transfer printers using resin or resin/wax ribbons. With special wax or solvent based inks also inkjet imprint is possible.
This white, matt PE film is perfect for permanent label application both indoor and outdoor.
Due to the reduced inner stability the film splits when removing it from the labelled surface. It is thus often used as a safety label.
Recommended storage
See HERMA website: www.herma.com/material/storage-conditions/
Regulations concerning contact with food
HERMA PE white PRINT (810) is in compliance with Commission Regulations (EC) no. 1935/2004 and (EU) no. 10/2011 and subsequent amendment up to and including no. 1627/2023/EU on plastic materials and articles intended to come into contact with food and furthermore with the Commission Regulation (EC) no. 2023/ 2006 on good manufacturing practice for materials and articles intended to come into contact with food. The composition of the film also complies with all purity criteria in accordance with European Commission Regulation No 231/2012 and Resolution AP (89) 1.
The film may stand in direct contact with all types of food except acidid foods and within the following durations:
- For refrigeration or freezer conditions (5° C or lower) storage time is unlimited storage time.
- Storage time at ambient temperatures (20° C - 40° C) is limited to 30 days.
Disclaimer
All statements, technical information and recommendations regarding HERMA products are given in good faith and are based on tests that we believe to be reliable, but do not constitute a guarantee or warranty. We give no guarantee as to the suitability of the product for a specific application, this should be tested by the user. Unless otherwise agreed in writing, we only accept liability within the scope of our General Terms and Conditions of Delivery and Payment.
HERMA GmbH, Adhesive Material Division, 70791 Filderstadt, Phone +49 (0) 711 7702-0
Demander un échantillon
Il suffit de demander votre échantillon du produit via notre formulaire.
